See Power Config for additional power config details.
from message meshtastic.Config.PowerConfig
Ratio of voltage divider for battery pin eg. 3.20 (R1=100k, R2=220k) Overrides the ADC_MULTIPLIER defined in variant for battery voltage calculation. Should be set to floating point value between 2 and 4 Fixes issues on Heltec v2
from field: float adc_multiplier_override = 3;
I2C address of INA_2XX to use for reading device battery voltage
from field: uint32 device_battery_ina_address = 9;
If set, we are powered from a low-current source (i.e. solar), so even if it looks like we have power flowing in we should try to minimize power consumption as much as possible. YOU DO NOT NEED TO SET THIS IF YOU'VE set is_router (it is implied in that case). Advanced Option
from field: bool is_power_saving = 1;
Light Sleep Seconds In light sleep the CPU is suspended, LoRa radio is on, BLE is off an GPS is on ESP32 Only 0 for default of 300
from field: uint32 ls_secs = 7;
Minimum Wake Seconds While in light sleep when we receive packets on the LoRa radio we will wake and handle them and stay awake in no BLE mode for this value 0 for default of 10 seconds
from field: uint32 min_wake_secs = 8;
If non-zero, the device will fully power off this many seconds after external power is removed.
from field: uint32 on_battery_shutdown_after_secs = 2;
Super Deep Sleep Seconds While in Light Sleep if mesh_sds_timeout_secs is exceeded we will lower into super deep sleep for this value (default 1 year) or a button press 0 for default of one year
from field: uint32 sds_secs = 6;
Wait Bluetooth Seconds The number of seconds for to wait before turning off BLE in No Bluetooth states 0 for default of 1 minute
from field: uint32 wait_bluetooth_secs = 4;
Create a deep copy.
Compare with a message of the same type.
Parse a message from a JSON value.
Serialize the message to binary data.
Override for serialization behavior. This will be invoked when calling JSON.stringify on this message (i.e. JSON.stringify(msg)).
Note that this will not serialize google.protobuf.Any with a packed message because the protobuf JSON format specifies that it needs to be unpacked, and this is only possible with a type registry to look up the message type. As a result, attempting to serialize a message with this type will throw an Error.
This method is protected because you should not need to invoke it directly -- instead use JSON.stringify or toJsonString for stringified JSON. Alternatively, if actual JSON is desired, you should use toJson.
Serialize the message to a JSON string.
Generated using TypeDoc