Detection Sensor Module Config


from message meshtastic.ModuleConfig.DetectionSensorConfig




detectionTriggeredHigh: boolean

Whether or not the GPIO pin state detection is triggered on HIGH (1) Otherwise LOW (0)


from field: bool detection_triggered_high = 7;

enabled: boolean

Whether the Module is enabled


from field: bool enabled = 1;

minimumBroadcastSecs: number

Interval in seconds of how often we can send a message to the mesh when a state change is detected


from field: uint32 minimum_broadcast_secs = 2;

monitorPin: number

GPIO pin to monitor for state changes


from field: uint32 monitor_pin = 6;

name: string

Friendly name used to format message sent to mesh Example: A name "Motion" would result in a message "Motion detected" Maximum length of 20 characters


from field: string name = 5;

sendBell: boolean

Send ASCII bell with alert message Useful for triggering ext. notification on bell


from field: bool send_bell = 4;

stateBroadcastSecs: number

Interval in seconds of how often we should send a message to the mesh with the current state regardless of changes When set to 0, only state changes will be broadcasted Works as a sort of status heartbeat for peace of mind


from field: uint32 state_broadcast_secs = 3;

usePullup: boolean

Whether or not use INPUT_PULLUP mode for GPIO pin Only applicable if the board uses pull-up resistors on the pin


from field: bool use_pullup = 8;

fields: FieldList
runtime: ProtoRuntime
typeName: "meshtastic.ModuleConfig.DetectionSensorConfig" = "meshtastic.ModuleConfig.DetectionSensorConfig"


  • Parse from binary data, merging fields.

    Repeated fields are appended. Map entries are added, overwriting existing keys.

    If a message field is already present, it will be merged with the new data.


    Returns ModuleConfig_DetectionSensorConfig

  • Serialize the message to binary data.


    Returns Uint8Array

  • Override for serialization behavior. This will be invoked when calling JSON.stringify on this message (i.e. JSON.stringify(msg)).

    Note that this will not serialize google.protobuf.Any with a packed message because the protobuf JSON format specifies that it needs to be unpacked, and this is only possible with a type registry to look up the message type. As a result, attempting to serialize a message with this type will throw an Error.

    This method is protected because you should not need to invoke it directly -- instead use JSON.stringify or toJsonString for stringified JSON. Alternatively, if actual JSON is desired, you should use toJson.

    Returns JsonValue

  • Serialize the message to a JSON value, a JavaScript value that can be passed to JSON.stringify().


    Returns JsonValue

  • Serialize the message to a JSON string.


    Returns string

Generated using TypeDoc